Products
Product Center
product Name:
FGA1101-QL Mainteness-free Energy-saving Explosion-proof Light
Product Series:
Explosion-proof
Product Parameters:

1. Execute GB3836.1, GB3836.2 and GB3836.3, "Explosive Environment Parts 1 to 3" (equivalent to IEC60079 and EN series standards). GB12476.1, GB12476.5 "Electrical Equipment for Flammable Dust Environments, Parts 1 and 5" (equivalent to IEC61241 and EN series standards).

2. Explosion-proof mark: Ex deIICT6 Gb; Ex tD A21 Ip65 T80°C

3. Shell protection rating: IP65.

4. Rated working voltage: 220V, 50Hz.

5. Light Source: electromagnetic induction

6. Watt: 40W; 50W.

7. Anti-corrosion grade: WF2.

8. Introduction port: G3/4".

9. Cable outer diameter: Φ9 ~ Φ12.5mm.



*Note: Product pictures and information parameters may not be reproduced in any form without authorization, otherwise they will be held liable.


product Description

Product Features

1. The explosion-proof type of the lamp is gas explosion-proof composite type or dust explosion-proof type, which is suitable for lighting in gas or dust explosion hazardous places.

2. The luminaire is mainly composed of an explosion-proof light source cavity (ballast cavity) and an increased safety type inlet cavity.

3. The lamp housing is die-casted from aluminum alloy, and the outer surface of the lamp is sprayed with polyester powder.

4. The light source cavity contains electric appliances such as light source, ballast and terminal block. The inlet cavity contains user terminals. A specular reflector is provided inside the light source cavity.

5. Tempered glass translucent cover, high light transmittance and good impact resistance.

6. The lamp has the advantages of good corrosion resistance, high luminous efficiency, wide illumination range, soft light and durability.

7. The flameproof joint surface of the lamp can be equipped with rubber sealing ring to improve the protection performance of the lamp, and it is suitable for outdoor or dust explosion-proof places.

8. The lamp has compact structure and novel design, which is suitable for low-bay lighting.

9. The shape of the lamp is divided into A type and B type. Type A is suitable for pipe hanger type, ceiling type (B1), suction wall type, and pole type installation, and type B is suitable for ceiling type (B2) installation (see installation diagram). In addition to the pole-mounted installation, the installation port is usually equipped with wires to facilitate user installation, and it can also avoid the explosion-proof and protective performance of the lamp due to improper installation.

10. The luminaire can be equipped with an explosion-proof emergency power supply unit. When the power supply network suddenly fails and the normal illumination stops, the luminaire can automatically switch to the emergency lighting state in an instant. Emergency time 30, 60 minutes or 90 minutes is optional.

11. This luminaire is suitable for external electromagnetic induction light source. The light source has the advantages of long service life, high luminous efficiency, soft light, good shock resistance, and long-term use and maintenance-free. If the luminaire is shock-proof, it can be used in a strong vibration environment (if the user has anti-shock requirements, it should be stated when ordering).


Application

Applicable to IIA, IIB, IIC containing explosive gas or steam environment, the temperature group of T1 ~ T6 in Zone 1 and Zone 2 indoor and outdoor hazardous sites or flammable dust environment, the minimum ignition temperature of a certain thickness of the dust layer is higher than General lighting or emergency lighting in Zones 21 and 22 as required.